Wednesday 5 February 2014

Logan assembled and more work on Hulk's skin tone

As I try out different skin tones for The Hulk, I decided to proceed with my Marvel Universe painting project by completing the assembly of the Knight Models Logan white metal miniature.The pose adopted by this miniature closely resembles Logan as seen in the movie titled 'The Wolverine'.

Knight Models Logan, fully assembled

Assembly of this metal miniature was relatively easy except for the claws on Logan's hands. The thin blade's small surface area made gluing them to the hands a challenge. But that was solved by using a combination of sodium bicarbonate and super glue, a topic I touched upon in an earlier post

Logan's pose seems to be based on the movie 'The Wolverine'

After being attached, the joints of some parts needed to be filled in with green stuff to smooth out the flesh sculpture. It wouldn't do to have any gaping holes that would break the illusion of real flesh.

Using green stuff to helped smooth out the flesh sculpture

Figuring out the colour scheme for Logan is a no-brainer as he should be clad in a white singlet and jeans which are either the traditional blue or maybe in black or dark grey colours. But it's the simple colour schemes that are the most difficult to paint because the very nature of its simplicity makes any painting errors more painfully obvious to the naked eye. Moreover, it's tough to make simple colour schemes look interesting. But as Barney Stinson would say ... 'Challenge Accepted'. After all, isn't failure only a six-letter word? Sticks and stones, and all that jazz.    

Cool pose on Logan's right arm as it's in mid-motion

Meanwhile, I have managed to get some work done on the remaining two gretchins to try and get as close as possible to The Hulk skin tone as seen in the Sideshow Collectibles figure. For these two gretchins, I went with a highlight that incorporated a very light flesh colour. Additionally, the gretchins were finished off with a very diluted wash comprising dirty green/flesh mixture. Both the gretchins' pants looked rather flat so I might repaint them if I decide to complete the whole 'Ork Heavy Support' set which would entail painting two Big Gunz - one for each pair of Gretchins. 

Hulk skin tone experiment on Ork Gretchins continues
Grime and verdigris on the shell means it will likely explode in the Big Gunz
Not much contrast work was done on the pants as both minis were skin tone practice pieces
Skin tone on the left figure was smoother because it was prepared with a black undercoat vs white on the right

Resulting colours were still a little too green but the highlights were much closer to the Sideshow Collectibles Hulk figure. This means if I wish to paint skin tone in a similar vein to the Sideshow Collectibles figure, I will have to use the current highlight as a mid-tone and look for a brighter shade for the final highlights. But the increased chalkiness that comes with adding pale flesh-like colours into the final highlights might require me to compromise and settle for a greener skin tone overall.

Sideshow Collectibles Hulk skin tone versus my Gretchin test skin tone

If you look closely enough, a comparison to my earlier gretchin test subjects (located on the extreme right and left of the foursome below) will show you that the latest two gretchins I painted sport a much lighter/paler shade of green. Effects are reasonably subtle but it's there. 

Ork Gretchins stand ready to man the Big Gunz
Gretchins on the extreme left and right are from an earlier Hulk skin tone experiment

As I dabble with assembling Logan and practising Hulk's skin tone, I am also close to finishing the paint jobs of Ser Gregor Clegane and a knight from House Baratheon (Renly version) in my Game of Thrones project. Once completed, I will be able to start on a knight from a yet to be decided Westeros House as well as a paint job conversion of an Ax Faction miniature into a wilding. Additionally, work will begin on a beautiful Nocturna Models miniature called Le Petit Chaperon i.e. either paint her as Red Riding Hood or convert her into Marvel's Black Widow, who is after all the master of disguises. On top of all that, I hope to start painting some W40K stuff again. Phew ... do stay tuned!

http://shireworks.blogspot.com/p/knight-models.html

6 comments:

  1. Great figure Logan , great paint and colors green on irks .
    Greetings
    Vincent .

    ReplyDelete
    Replies
    1. Yes I agree ... the Knight Models Logan metal miniature has a very dynamic pose and is nicely sculpted. =)

      Delete
  2. Your work on the green colors is awesome...and the poses are excellent too, you're right!

    ReplyDelete
    Replies
    1. Thanks Phil ... I am getting a bit better at blending different shades of green. :)

      Delete
  3. Replies
    1. As The Hulk's main attribute will be his skin, to mess that up would be to mess up the whole miniature. Thanks for your kind comments. =)

      The greens of the ork gretchins on my laptop screen look very much like the Sideshow Collectibles Hulk skin tone but it looks a tad greener on mobile devices. Not sure what screen settings are causing this anomaly.

      Delete

Related Posts Plugin for WordPress, Blogger...